nobody?

 

It should auto-select the first 15 PIDS to log, then after you log it and open the log file under Dashboard (B), you can view many PIDS at once (maybe 8 or so) and you can change the ones that it displays. Let me know if this helps.

 

yes, that helps. im just not sure if the 15 PID's it selects are going to give me info on my cp3 and injectors which are the only things i can really think of that may be causing my bad fuel mileage.

 

your CP3 info should already be selected (when viewing the log, look at desired rail pressure vs. your actual rail pressure. they shouldn't differ by more than a couple thousand at most throughout the RPM range).

For your injectors, you'll wanna select all eight balance rates PIDS and check them vs. factory specs. IIRC, they should be between +/- 4mm3 each @ idle in park. Outside that, and you may have a bad injector. Let me know how it turns out.

 

its showing that the injector balalnce rates are not supported... should i select them anyway?

 

Connect to your truck, open scan tool, at the top click the "info" drop down then click "validate pids" and see if the balance rates are supported then. Sometimes when I look up pids when i'm not connected to my truck it will say not supported but when I'm connected they work. Good luck.

 

ok, so when i try and start datalogging i get an error. heres what it says


Error code: ERR_RESPONSE/5
Response $11: "Mode Not Supported".

theres a bunch of other **** after that. but thats the main thing. i updated to build 88. still wouldnt work.

any idea?

 

Sorry, can't help with that. Hopefully cindy will see this, she will be able to help.

 

ok, i got it. i think i was trying to log too many pid's.

so my injector balance rates at an idle were like this.

#1: 2.80
#2: 1.09
#3: -1.95
#4: -0.05
#5: -0.41
#6: -1.85
#7: -0.97
#8: -1.22

is this ok?

my rail pressure seemed to hold within 1500-2000 of desired. it would drop a few thousand during shifts put would pull back up.