Diesel Place banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2,149 Posts
Discussion Starter · #1 ·
All i need is a 124" serpintine belt and ill be pumping air

The install was not that hard but more time consuming than anything. I decided to put a York model 210 A/C compressor where the second alternator goes. I have not installed a tank at this time as I'm getting ready to paint it. The pictures are horrible I know. Sorry, cheap camera.



The brackets​


I forgot to take pictures while I was making the brackets but here is a before and an install. The bracket I used was out of an 78 Ford if I remember correctly. I cut the entire left side of the bracket off. I used the right side to mount the compressor. I welder a piece of angle iron to the original bracket and mounted it to the two holes on the Duramax A/C compressor. I did it this way so the York would be high enough that i could still get to my power steering reservoir.



Removing the Ground Plate for install.



Mounting the compressor was a little harder. I had to remove the bracket that has the ground plate and the terminal block on it(top picture). I totally took it off. The terminal block just has a little tab you push in to release it from this bracket. I tucked the terminal block under the compressor(bottom picture). I also took of the radiator hose and ran the battery cable under it.



Mounting the Compressor.


Thats the easy part. Just bolt it up. I looked at the belt line up from the top and both sides to be sure it was lined up.






Installed the pressure switch and air/oil separator.


Heres a side view. It doesn't really matter were you mount them. I bolted the pressure switch to the top of the compressor. I zip tied the separator to the brake reservoir. I will mount them a little different later. All of this stuff will come apart in the spring to be painted.

 

·
Registered
Joined
·
2,149 Posts
Discussion Starter · #2 ·
After all those people were asking for pics on a york install. Cant belive no one has replyied.



Does anyone know were I can get a 126" Serpintine belt?
 

·
Registered
Joined
·
2,149 Posts
Discussion Starter · #4 ·
1200 RPMs for 8 CFM if IIRC. I had it on my old truck. I painted the truck using its own compressor. With the truck at idle it keep up with the paint sprayer.
 

·
Registered
Joined
·
2,149 Posts
Discussion Starter · #8 ·
I think it came of a 78 ford truck. dont know much other than that. You could easyily make a braket out of a piece of plate and a piece of angle. You can get the pully from onboardair.com $115 A peterbuilt dealer $85 + $10 core or you could make on like I did. I took the dual v belt pully off the compressor and mounted it to a lathe. I just took the Center rib off the pully.
 

·
Registered
Joined
·
2,149 Posts
Discussion Starter · #9 ·
I knew I had it somewhere

1000 rpms 6.94 CFMs
2000 rpms 13.89
3000 rpms 20.83
4000 rpms 27.78
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top