Diesel Place banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I'm installing the HSP Y-Bridge Kit with both intercooler tubes and inlet horn. I just finished installed a CP3 fuel pump - and that was a freaking ***** and a half!

So....
How in the hell do you get the freaking bolts started on the freaking Y-Bridge?? I have been banging my head for the past 3 hours trying to get the Y-Bridge on (yea, 3 hours on just trying to get it on - been 3 days that I have been working on the truck).
I cannot seem to get ANY of the bolt started no matter how hard I push on the Y-bridge, and yes, the nuts are completely removed from the studs - it is sitting where it goes, just wont go down far enough to install any bolts.

Thanks in advance!
Mike
 

·
Premium Member
Joined
·
1,461 Posts
Are there any o-rings that need to be lubed?
 
1 - 4 of 4 Posts
Top