Diesel Place banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi All,

I am working on a J1939 scantool and would like to get my hands on an ECM so I could test on the bench. Could someone tell me where I could get my hands on an ECM that supports J1939 and where the pinout is available so I can hook into the can bus to test my scantool?

Thanks
Jay
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top