Diesel Place banner
1 - 5 of 5 Posts

· Registered
Joined
·
77 Posts
Discussion Starter · #1 ·
Darn... my digital camera is down. I've replace my IP but can't figure out where one of the connectors from the wiring harness goes.

It is the only 6 pin plug (3 on top row, 3 on bottom row female connector) off the harness that travels underneath the intake manifold. It has a blue seal on it. It is a black plug.

It is not the PMD connector. It is not either connector that goes on top of the intake manifold.

It can't be far off the passenger side of the IP. But I can't find anything.

Sorry, I know this would be easier with a pic.

Thanks for any suggestions.
Bill
 

· Registered
Joined
·
376 Posts
Sounds like maybe the connector for the optic sensor filter.
 

· Registered
Joined
·
3,576 Posts
When you replace the IP the optic sensor on it comes with a plug in place to protect the receptacle, remove the protector and plug it in.
 

· Registered
Joined
·
77 Posts
Discussion Starter · #5 ·
Oh... and I thought that was just a pretty piece of black rubber on there. :)

I already sent back the old one so I didn't have an IP to compare.

Thanks, guys, Problem solved.

Bill
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top