Diesel Place banner
1 - 5 of 5 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
I'm looking to install a tiny-tach ( http://www.tinytach.com/tinytach/diesel.php ) on the truck I purchased earlier today, but I need to know what sice the injector lines are. I've done a few searches, but haven't spotted the answer.
 

·
Registered
Joined
·
6,412 Posts
Welcome to the forum!

I don't know off the top of my head the answer to your question (although I think it's like 3/16"), but as I recall all you need is the outside diameter and you should be able to measure that fairly easily...
 

·
Registered
Joined
·
24 Posts
Discussion Starter · #4 ·
given that the different sizes are 6mm, 7mm, and 1/4" I don't trust my measureing skills to get the right one :)

I've got one of the military blazers if it makes any difference
 

·
Registered
Joined
·
52 Posts
Dear Injector Line Diameter Seekers Of The Past,

I have come from the future to tell you that the OD of the 6.2 injector lines is 0.25 in 1983.

So buy the 1/4 inch Tiny Tach.

Live Long And Prosper. 🤣
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top