[G Livingstone]

Hi Guys,
Can anyone tell me what tools are required to remove and replace the injection pump lines, in particular the pump end?
I have heard a crows-foot is the anwser.

 

[DieselPro]

A Snap-on four way 3/4" open end wrench or equivilant.

http://buy1.snapon.com/catalog/item.asp?P65=&tool=all&item_ID=5236&group_ID=560&store=snapon-store&dir=catalog

 

[94blazer6.5]

When I replaced my IP the only tool I needed was patience and lots of it. 3/4 Line wench worked for me, But I'm sure a crow foot will work too.

 

[DavidPhillips]

I used a craftsman metric end wrench. Only thing is the lines must be done in exact order on and off to be able to tighten them with them getting in each others way.

Write down the order of removal and it's a snap to do it in reverse.

Or do it like me and then it's like a little game trying to figure it out.

 

[midniteplowboyy]

Crows foot works well, if not do as david said. Most are 16mm(5/8"), but I think some were 17mm I've heard.

 

[qwomack]

A Snap-on four way 3/4" open end wrench or equivilant.

http://buy1.snapon.com/catalog/item.asp?P65=&tool=all&item_ID=5236&group_ID=560&store=snapon-store&dir=catalog

That's what I use without any problems.

 

[midniteplowboyy]

I think the IP end of the lines are 16mm or 5/8", the injector ends of the line are 19mm or 3/4".