Diesel Place banner
1 - 3 of 3 Posts

·
Registered
Joined
·
382 Posts
Discussion Starter · #1 ·
I've had this problem once before and was able to correct it. But now I have tried everything I can think of and have run out of options.

When viewing a scan in the tune program and watching Main Inj. Pulse, the 190 column is highlighted only and the rows will switch but it only stays in the 190 mpa column.
 

·
Registered
Joined
·
931 Posts
make sure units are set the same in scan tool and tuning tool. If not switch (metric or imperial) at the pid selection
 

·
Registered
Joined
·
382 Posts
Discussion Starter · #3 · (Edited)
make sure units are set the same in scan tool and tuning tool. If not switch (metric or imperial) at the pid selection
double checked all of this and still same result. I am just short of reinstalling everything.
 
1 - 3 of 3 Posts
Top