Diesel Place banner

1 - 8 of 8 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
I started my truck this morning and walked away from it to let it warm up and i didn't even get 10 feet away and it stalled. I tried to restart it, but it wouldn't start. I figured it was the fuel filter as i hadn't changed it in a while. So i just got around to changing it now, tried to start it and nothing. It still won't start. Any ideas? I will be calling the dealership tommorow to have it towed in as it is still under warrenty.

Cliff
 

·
Registered
Joined
·
53 Posts
Were you able to prime the new filter without problems after changing it?
 

·
Registered
Joined
·
18 Posts
Discussion Starter #3
Yes i primed it as usual.
 

·
Registered
Joined
·
382 Posts
where are you located? What is the temp outside?

If it is extremely cold out you should put some antigel additive in the tank and filter when changing it
 

·
Registered
Joined
·
18 Posts
Discussion Starter #5
im on the jersey shore. It's 30 degrees outside, but it was 7 last week with no problems.
 

·
Registered
Joined
·
10,556 Posts
So you are getting fuel out of the bleeder?

Do you have a code scanner?
 

·
Registered
Joined
·
447 Posts
Try disconnecting the EDGE.
 

·
Registered
Joined
·
18 Posts
Discussion Starter #8
Yes i got fuel out of the bleeder and the edge is diconected.
 
1 - 8 of 8 Posts
Top