2006 Sierra 2500HD
If you had to do it over, which option?
Pre-cut/bent SS kit ($155) or Precut Nicopp kit ($90)
Its not so much the cost. The question is related to routing the lines and getting them in the truck. I don't have a lift.
Don't offer up buy roll of tube and craft it myself...
HALP! 4x4 not engaging. Replaced the front diff actuator. Can hear the transfer case switch when it’s not running. 15 amp fuse is good. The service 4wd is not on. The buttons on the dash work as they should. It’s telling me to service the brakes on the dash with both the abs and parking brake...
I have a 2006 LBZ. My brakes have gotten pretty spongy over time, so I pop the hood to find a signs of a leak around the master cylinder and hydro booster. Both the master cylinder and the hydrobooster's exterior have a fair amount of grease/grime built up on them.
When I checked the levels of...
the brakes work fine . the last 2-4 ft if feel pulsing in brakes. put only last few feet. any ideas what it could be all fluids fine. just a bit unnerving. truck in signature. check rotors and pads too, they were fine.
Hey guys. So I’ve noticed here lately that when going approx 40-60 mph that if I try to accelerate I’ll get a grinding noise. The truck is an 07 LBZ crew cab 4x4 with a spade tuner. Drive it most of the time in economy mode unless towing, adds 100 hp. Makes the noise while in 2wd, haven’t...
A forum community dedicated to Chevrolet and GMC diesel truck owners and enthusiasts. Come join the discussion about duramax engines, performance, builds, modifications, classifieds, troubleshooting, maintenance, and more!
Captain-A · updated 
