Diesel Place banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
106 Posts
Discussion Starter #1
Looking for a EGT gauge that comes with a 1/8 thermo. probe. Most I have found searching have the 1/4 fitting. Already have the 1/8 hole in the manifold, and don't want to drill again.
Thanks,
John
 

·
Registered
Joined
·
363 Posts
I believe that the probes will interchange. I have a 1/8 that came with my TST PowerMax. It has screw type connectors. Maybe one of the vendors can help you out.
 

·
Registered
Joined
·
3,291 Posts

·
Registered
Joined
·
1,460 Posts
just drill it you already have a hole it will take no time at all to redrill it just drill while you have the engine running so the meatal will get blown out
 

·
Registered
Joined
·
302 Posts
NAPA has and brass fitting that will go from 1/8" NPT male to 1/4" NPT female. That's what I did. I think it ran <$5.
 

·
Registered
Joined
·
1,549 Posts
1 - 7 of 7 Posts
Status
Not open for further replies.
Top