Diesel Place banner
1 - 1 of 1 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Have a 02 crew shortbed 4wd. Bought a superchip programmer. Love the power on high(approx 80+ hp). But crusin at 70 to 80 mph, a full pedal downshift from 5 to 4 will apparently slip a bit and set a tranny code and shut down 5th gear. I erase the codes and then all is well. But I wonder if this is "normal" or if my ally is perhaps a bit weak up there. Or if I should just keep my foot away from the floor at that speed. All other shifts are quick and tight, even hammering wide open from a start. Any comments appreciated. Del
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top