Diesel Place banner
1 - 7 of 7 Posts

· Registered
Joined
·
115 Posts
Took mine off and replaced with a new one from ebay. Pretty funny sticker
 

· Registered
Joined
·
361 Posts
yup.........did the same as king......
 

· Registered
Joined
·
2,178 Posts
You need to use a tiny amount of heat - a hair drier on low. Be careful as too much heat = melted material. But they will come off.
 

· Registered
Joined
·
115 Posts
Yibbutkeen;1571004; said:
You need to use a tiny amount of heat - a hair drier on low. Be careful as too much heat = melted material. But they will come off.

X2 start at one corner with a bit of heat and slowly pull off while heating
 

· Registered
Joined
·
39 Posts
Did mine cold..

I had a Pepsi can explode in my truck at -25c... I ended up vacumming my truck out before it melted... and I sucked the sticker right off of the visor in pieces. It came off clean, for what it is worth. :D

Storman22
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top