Diesel Place banner

1 - 7 of 7 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
I currently have the juice on 90 and the superchip on stage 2. I didn't remove the edge when I installed the superchip, and had no problems. Now I want to back out the superchip so i can run the hot juice. Do I have to remove the edge 1st? Just asking b/c I was told that it might lock up the vin # in the superchip if I don't remove the edge.
 

·
Registered
Joined
·
1,251 Posts
I have never had a problem with doing that, but not to say you or somebody else doesn't. If your worried, pull the juice, it only take 30 secs.
 

·
Registered
Joined
·
1,715 Posts
DITTO
 

·
Registered
Joined
·
795 Posts
heartbeatcanada said:
I have never had a problem with doing that, but not to say you or somebody else doesn't. If your worried, pull the juice, it only take 30 secs.




You guys must be young.


It takes me more than 30 seconds to just crawl upon the engine. Then of course I have everthing tie straped down, so you have to cut the straps. And of course you know atleast one of the damn harnesses will be stuck, so you have to get something to try and pry the that harness apart. etc etc. "Murphy" (law) is always in my garage
 

·
Registered
Joined
·
1,715 Posts
4 minutes to change an ECM
practice makes perfect
 

·
Registered
Joined
·
124 Posts
sdaver said:
4 minutes to change an ECM
practice makes perfect
hot or cold? and how long to swap your juice?
 

·
Registered
Joined
·
17 Posts
Discussion Starter #7
Thanks for all the feed back.
 
1 - 7 of 7 Posts
Top