Diesel Place banner
1 - 7 of 7 Posts

· Registered
Joined
·
152 Posts
Discussion Starter · #1 ·
I have a 2003 2wd truck with a 2-piece drive shaft. Is the yoke on the back of the transmission a slip yoke?

I want to convert this to a 1 piece shaft. If this is not a slip yoke then I will need to replace this also, right?

Thanks.
 

· Registered
Joined
·
305 Posts
bpicard;1542397; said:
I have a 2003 2wd truck with a 2-piece drive shaft. Is the yoke on the back of the transmission a slip yoke?

I want to convert this to a 1 piece shaft. If this is not a slip yoke then I will need to replace this also, right?

Thanks.
I have a 4WD with the two pc shaft and my yoke is a slip yoke at the transfer case.
 

· Registered
Joined
·
152 Posts
Discussion Starter · #3 ·
RanaExcavating;1543823; said:
I have a 4WD with the two pc shaft and my yoke is a slip yoke at the transfer case.
Rana! Thanks.

I have a 2wd truck and I can't tell is there is a slip yoke on the transmission.

Thanks again.
 

· Registered
Joined
·
2,899 Posts
it isn't hard to tell if there are any bolts on the drive shaft at the end of the trans then it isn't but i believe that it is a slip yoke
 

· Premium Member
Joined
·
3,598 Posts
I thought the '04's were all one piece? I vaguely remember it beign disgussed already, but what differentiated between the one piece an the two piece? Different option?
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top