Diesel Place banner
1 - 6 of 6 Posts

·
Registered
Joined
·
108 Posts
Discussion Starter · #1 ·
I have a quadzilla on my 06 lbz and I have pulled a code that is a 2610. When I clear it out with my programer, it last for a bout 5 minutes then it comes back on. Any ideas?
 

·
Registered
Joined
·
683 Posts

·
Registered
Joined
·
4,340 Posts
You get the P2610 code from leaving the ignition on too long without starting the engine while your tuner is loading the tune to your ECM. I rerun the tuner after I load a tune in and just check for DTC's just in case this one pops up, then I clear it and shut the tuner off. That usually keeps it away. Just for the record, I used a Hypertech PP3. ;)
 

·
Registered
Joined
·
4,340 Posts
PS: Moved to the OTHER 3rd Gen section. The one that deals with 3rd GEN ELECTRONICS! :D
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top