Diesel Place banner

1 - 2 of 2 Posts

·
Registered
Joined
·
12,036 Posts
Discussion Starter #1
Lowest pull 241.3hp, highest 246.7, torque = unreliable. DynoJet at DynoWorks in San Berdo.


Vehicle 2004.5 3500 SRW 4x4 DA Sierra w/~8000mi. Bone stock.


Torque is unreliable due to turbo lag and lack of a Tech II to get down in the RPM scale to where the peak torque really is.


Printout says 500/496/436/422 as peak torques. Powerband is flat. Fuel shutoff occurred at ~3275rpm. Pulls in 4th gear, no fan, engine at full operating temperature.
 

·
Registered
Joined
·
212 Posts
McRat,


Mine was 245.9 on BD's Mustang dyno. Approximately the same as my LB7. Torque unknown, was going to re-dyno after all the others were done, but run out of time. It does seem to have a little more power than my LB7 stock though. tpitt


P.S. Another one bone stock also was 245.8 with 160 miles on it. Mine was at about 2100 miles at the time.
 
1 - 2 of 2 Posts
Top