Diesel Place banner

1 - 4 of 4 Posts

·
Registered
Joined
·
263 Posts
Discussion Starter #1
Does anyone know where to get a rpm signal from when doing a dyno? I went and had my truck dyno today and my dmax was the first one he has ever done. We could not get a torque read.
 

·
Registered
Joined
·
12,262 Posts
You need a optic sensor .... Reading is taken off the crank pulley via sensor mentioned and a strip of reflective tape attached to the pulley....

Mac
 

·
Registered
Joined
·
263 Posts
Discussion Starter #3
Thanks... Mackin
Edited by: easymon4u
 

·
Registered
Joined
·
4,755 Posts
On a DynoJet you can use the injector signal to get RPM. We use the loom of wires just uder the turbo discharge hose on the driverside to get the signal.
 
1 - 4 of 4 Posts
Top