Diesel Place banner

prop shaft swap

Question: 
626 views 2 replies 3 participants last post by  Rvn4me 
#1 · (Edited by Moderator)
I have a 2002 lb7 4 door standard bed truck 2 piece prop shaft. I have been given a 1 piece from a 2012 4door standard bed. before o go through the effort of swapping has anyone else tried. and are they the same? the 3 piece has a bad launch shudder. goes away with new center support and comes back in about 10k miles.
 
#2 ·
Welcome to DieselPlace

:thumb:
 
#3 · (Edited)
You should measure them to see if it will work.
A lot of people did the two piece to one conversion.
The aluminum drive shaft is stronger than the OEM 2 piece drive shaft.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top