[MKILROY]

I am going to finally Shim my FPRV on Sat. and I am a little nervous but very mechancilly inclineded. I started reading the instructions and is it me or is Step 9 before Step 8???? Thanks for the help

http://www.pacificp.com/pdf/manuals/ShimKit.pdf

 

[dozerboy]

McRat did a DIY post IIRC

 

[hinesdg]

Shimming the FPRV is the simple part...breaking it loose for the first time is the trick. I had to use a 4' pipe on the wrench to break it. I was just about to give up...in fact, I had given up on it once and tried to run without it shimmed and got into the throttle too hard and put my truck into limp mode.

 

[MKILROY]

is it a 20mm Box wrench you need to pull it out?

 

[MKILROY]

Dozerboy I can't find Rat's DIY? Can you post a link? thanks

 

[MKILROY]

found it Thanks