Diesel Place banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,069 Posts
Discussion Starter #1
I am in the process of adding power locks to my w/t trimmed truck. I have the actuators installed and the brain wiring figured out at this point. The system comes with a starter kill switch and relay and now I need to tap into one of the wires to make this feature work. Does anyone know which wire I should use and if a 40amp relay is appropriate?
Thanks ahead of time.
 

·
Registered
Joined
·
16,617 Posts
40 amp relay is more then enough. Look for a yellow wire coming from teh steering column. It will test 12v when the key is in the crank position only.
 

·
Registered
Joined
·
1,069 Posts
Discussion Starter #3
Thanks Max Power....I had an inkling you might chime on this one!!!
 
1 - 3 of 3 Posts
Top