Diesel Place banner
1 - 6 of 6 Posts

·
Registered
Joined
·
124 Posts
Discussion Starter · #1 ·
Alright folks, debating a fabtech 4" spindle/block lift or a 7 1/2" fabtech lift. I just bought some 19.5" rims with 245/70s and they stand appx. 32.5" tall.

I know my 2wheel drive truck is lower stock than a 4x4 so its hard for me to judge how it will look when I look at a 4x4. I want to go high, but I don't want to look goofy.. don't want to be too low either.

Opinions needed please... let me know what you experiences folks think!

4" or 7 1/2" ? Thanks all...

This picture is of the rims on a newer chevrolet dually 4x4. I dont know if this truck has been lifted or not.
 

Attachments

·
Registered
Joined
·
124 Posts
Discussion Starter · #2 ·
Anyone?
 

·
Registered
Joined
·
1,798 Posts
4" kit will be fine.... 7" will look funny
 

·
Registered
Joined
·
3,136 Posts
ya the 4" would be perfect unless you are wanting to put larger tires on it but if you are going to stick with the 32's then i wouldn't go any taller then 4"
 

·
Registered
Joined
·
124 Posts
Discussion Starter · #6 ·
Ok, that solves it then. I really didnt want to do the 7 1/2incher anyway. I just didnt want to come out looking wierd.. want to be tall, not looking wierd though.. thanks a bunch folks!
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top