Diesel Place banner
1 - 2 of 2 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
The inst. sheet doesn't say but my guess is I need to take a Dremel tool and cut out the plastic inserts where the lamps go. Before I start cutting, is there another way or do I cut as thought?
 

·
Registered
Joined
·
20 Posts
Discussion Starter · #3 ·
Thanks for the reply. After further review of the install situation I have another question. It looks like I need to remove the pins that hold the plastic valance to the bumper. The two where the lamp frame reattaches. What's the best way to remove those? Just break/cut them off?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top