Diesel Place banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,005 Posts
Discussion Starter #1
Need to remove the oem drinkholders on my 40-20-40 bench seated 02. They're the ones that are virtually on the tranny hump. Unable to figure/see how to remove them. Has anyone done so? If so, how?


TIA
 

·
Registered
Joined
·
276 Posts
I don't know how to get them off, but they are kind in a dumb place aren't they...


cadman_ks
 

·
Registered
Joined
·
1,005 Posts
Discussion Starter #3
Sure are ~ really awkward for us and I did install a dash mounted drop down from a suburban like 56chevynomad did. Now I need more tranny humpspace for my CB mount w/enclosed speaker. Gr-r-r-r, perhaps a chainsaw can take care of it
Edited by: ShumDit
 

·
Registered
Joined
·
12,262 Posts
Helms manual says in open position "Remove the tabs that connect the cupholder to the floor console by gently prying apart with a flat bladed tool " ....

Tabs are located near inside center of cupholder in the PIC ....

Reassembly:

"Install the cupholder to the floor console by snapping tabs to console back piece "....

Mac
 

·
Registered
Joined
·
1,005 Posts
Discussion Starter #5
Mac ~ Much thanks !



Go'in tab huntin'
 
1 - 5 of 5 Posts
Top