Diesel Place banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
shift indicator acting goofy, replaced nsbu, installed in neutral and all that stuff now I have no indicator at all and it won`t shift at all!One of the pins on the switch came out with the plug could the plug be bad as well?Any info would much be apprciated!Thanks Mike
 

·
Registered
Joined
·
892 Posts
Which pin came out? The NSBU works by sending back the state of four switches (either on or off). Based on this combination the transmission module determines what range is selected. If you broke one of those pins or it's not making good contact it won't know what range is selected and it will give you a blank PRNDL and won't go into gear.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #3
thanks I`ll take a look at that I don`t know witch pin broke?
 
1 - 3 of 3 Posts
Top