Diesel Place banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have read a bunch of no-start posts and am struggling a bit

truck ran and started fine then sat for 4 days and would not start

fuel 1/2 tank
Pressurized tank could not see leak
Cranks without problem

I primed got air out of bleeder screw, then primed till hard, went to start and lost prime

did this again and got air again and again lost prime

primed and let sit for 5 min (did not try to start) and held prime

fuel at schrader valve by alternator

I don’t have a scanner to check codes

I have ordered a filter housing, filter and w/s to see if those fix

any other suggestions?
and seeing if anyone knows a good scanner?
 

·
Administrator
Joined
·
19,363 Posts
Welcome to DieselPlace
Inspect your fuel hoses for any kinks or cracks/dry rot. Old rubber line will collapse under suction from the CP3
if you can get your hands on a Tech 2 scanner or a clone would be best.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
So found out the problem
Broken wire under the under hood fuse block, ground from the ficm
 

·
Administrator
Joined
·
19,363 Posts
So found out the problem
Broken wire under the under hood fuse block, ground from the ficm
Glad you found the issue.
Thanks for giving us an update!
(y)
 
1 - 5 of 5 Posts
Top