Diesel Place banner

1 - 4 of 4 Posts

·
Registered
Joined
·
382 Posts
Discussion Starter #1
Got a '95 long block that had about 6,000 miles on a rebuild. Pulled the head bolts to use ARP studs. Everything looks great. Managed to mix up the pushrods:mad: so I should replace them right? Is there anything else I should replace to avoid excessive wear problems because I'm replacing the pushrods?

Thanks.
 

·
Registered
Joined
·
1,449 Posts
Just check them for wear. A visual inspection for pitting or abnormal wear patterns is all that is needed. Also rolling them on a very flat surface to check them for bends is a good idea. They really are not tempermental about having their positions changed if everything is in good shape.
 

·
Registered
Joined
·
382 Posts
Discussion Starter #4
Great! Thanks! Saved a few bucks!:D
 
1 - 4 of 4 Posts
Top