Diesel Place banner

need help...

724 views 8 replies 4 participants last post by  RickDLance 
MDE;1559305; said:
Hey Smoking

here a pic of an LLY engine (is the lest Injector (LLY):
http://www.dieselplace.com/forum/attachment.php?attachmentid=31514&d=1167787853

Untie all high pressure lines, remove leakage connector (take the clip away and pull connector out), untie the Metric 8mm screw under the injector and pull the injector out. Some Injectors are easy to remove and some are harder. Good luck!!!!

Volker
Be careful with that clip!!;) They tend to get away from you.

I've pulled several sets with no issues. Usually you can put a large screwdriver under the clamp, after removing the bolt, and pop the injector up.
 
There's also an injector pulling tool. The drawing is of it being used on an LB7, but it works on the LLY also.

Install the J 44639 to the fuel injector brackets.
Pull back on the J 44639 in one steady motion, until the fuel injector breaks free from its seat.
Remove the J 44639 .
 

Attachments

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top