[96GMC6.5L]

Seems that all I can find is three inch pipe out there. I found a place on e*** that does custom bends, and they said it would be around 50 bucks for a 409 stainless three inch muffler delete pipe to meet the offset of my muffler. The only thing I was wondering was if the three inch would work with the stock 2.75 inch exhaust, or do they have some kind of reducers or something to make this work? Because I don't think that is a bad price myself.

Thanks, Jacob

 

[Tracy]

The 3" pipe should work, its inside diameter will be only slightly larger than the 2.75 outside Dia. of the stock pipe, just enough to get it on. The stainless pipe is a bit stiff metal to bend and get a good seal with the clamps, it will likely work fine but just regular exhaust tubing would bend and seal a little better. Wish i could hear it run when your done, I've thought about doing this as well but have been afraid it maybe a little load for my taste let me know what you think of it.

 

[96GMC6.5L]

Right now my biggest problem is getting the cat off to gut it. Those bolts are on there some tight. I will keep you posted


Jacob