Diesel Place banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,704 Posts
Send the municipality a bill for sealcoating that section of road.

I'm tearing down some engines at the moment. One of them ran but had a slight knock, was beaten to death with low oil. Pan was full of shavings. BIG ones, three spun bearing. That engine also grooved the cam (lifters ok).

Pull the pan, check for debris, check for play on the bearings. The rods will be sloppy or have fuzz around the sides from the bearings spinning. It might be fine, it might not. I bet that it is if you still had some oil pressure. Hopefully the fire didn't get into the harness
 
1 - 1 of 1 Posts
Top