Diesel Place banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,240 Posts
Discussion Starter #1
<H1>Manual High Idle System Description</H1><A name=ss1-1343526><A href="http://service.gm.com/servlets/BlobShtml?ShtmlFile=1343526&evc=numSrch#ss1-1343526" target="_blank">
<H5>High Idle System</A></H5>


The diesel engine has a high idle system to improve the warm-up time of the engine in cold weather conditions. This system allows the engine control module (ECM) to increase the idle speed above the normal calibrated value. The ECM increases the idle speed using the following adjustments:
<UL =BULLET>
<LI>The fuel injection timing is changed.
<LI>The fuel injection quantity is changed.
<LI>The turbocharger vane position is commanded closed. the vane position will be farther closed than any other normal operating condition. </LI>[/list]


The instrument panel will indicate the high idle system is active one of two ways:
<UL =BULLET>
<LI>The Driver Information Center (DIC) will indicate an active high idle system on Light Duty Trucks.
<LI>An indicator lamp will flash on medium duty trucks. </LI>[/list]High Idle Speed Enable and Disable


To enable or disable the high idle system perform the following procedure:

  1. <LI =1>Turn the ignition ON with the engine OFF.
    <LI =1>Depress the accelerator pedal to the floor and hold down.
    <LI =1>While the accelerator pedal is depressed, depress the brake pedal 3 times in less than 8 seconds.
    <LI =1>Release the accelerator pedal.
    <LI =1>Start the engine. </LI>


When the procedure is followed the engine idle speed will slowly increased to the calibrated high idle speed. This is 1200 RPM for Light duty, and 1500 RPM for medium duty trucks.


The idle speed will return to normal if any of the following conditions occur:
<UL =BULLET>
<LI>There is brake, clutch, or throttle input from the driver.
<LI>The automatic transmission is shifted out of Park or Neutral.
<LI>The air temperature is more than 0 °C (32 °F).
<LI>The engine coolant temperature (ECT) is more than 68 °C (154 °F)
<LI>The vehicle speed exceeds 0 MPH (0 km/h). </LI>[/list]


The high idle system will reactivate automatically when the following conditions occur:
<UL =BULLET>
<LI>The engine has been idling for more than 30 seconds.
<LI>The transmission is placed in Park or Neutral.
<LI>the vehicle speed is 0 MPH (0 km/h).
<LI>The ambient air temperature is less than 0 °C (32 °F).
<LI>The ECT is less than 68 °C (154 °F)
<LI>The brake, clutch and throttle pedals are not depressed. </LI>[/list]
 

·
Registered
Joined
·
81 Posts
Is there any way to manually high idle the lly engines,like the lb7?
 

·
Registered
Joined
·
1,360 Posts
This procedure just turns the high idle system off or on. You can do the same thing with the DIC and the buttons on the steering wheel.


The ambient air temperature and engine coolant temperature have to fall below the listed range for the system to engage, and it does it automatically. Or at least mine does.
 

·
Registered
Joined
·
398 Posts
WOW, that's really A nice feature, wonder if it can be adapted over to the trucks with the LB7 engine?
 
1 - 4 of 4 Posts
Top