Diesel Place banner

1 - 7 of 7 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hi guys new to this site and had a couple of questions. I have a 06 Lbz duramax with 4,000 miles on it and have installed an s&b intake and a s/s cat back dual exhaust. want to take out cat and was wondering where to get the fingers and block off plate or if i need them, any help would be great
Also was going to run the edge evo and stack it with the Duramaxizer any opinions on that
 

·
Registered
Joined
·
50 Posts
You can get the block off plate from PPE at www.ppediesel.com, and odds are with the new exhuast and intake, you are going to throw a 401 or 404 code which are egr codes so i reccommand getting the entire EGR code eliminator kit from them too.
 

·
Registered
Joined
·
4,051 Posts
To my knowledge, PPE does not make the code eliminator for LBZs.
 

·
Registered
Joined
·
4,123 Posts
Fingers;1601001; said:
To my knowledge, PPE does not make the code eliminator for LBZs.
Yes, they do. I had one on Wendy. They also have it built into the tuners now.
 
1 - 7 of 7 Posts
Top