Diesel Place banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1
Tomorrow I'm going to install boost and pyro gauges on my dad's 01. The instructions that came with the gauge kit show a picture of the intake from a 2006 truck and the pipe is square shaped, thicker looking and in a different location than the pipe on my dad's truck. Is the intake pipe (post intercooler) on the lb7's thick enough to drill and tap?


Also I've read about guys "capping off the resonator" but on the 01 I don't see any kind of hole to cap off. Is this only for the VVT trucks?

Thanks for any help.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top