Diesel Place banner

1 - 2 of 2 Posts

·
Registered
Joined
·
9,300 Posts
Discussion Starter #1
I got my kit and was inspecting it. I put my finger in the "clean" hole of the filter head. When I pulled it out it was covered in metal shavings. Probably has casting sand in it as well. I will have to figure out how to give this a good cleaning before install.

I did send an email off to nictane.


Just FYI for all kit buyers......Edited by: problemchild
 

·
Registered
Joined
·
6,063 Posts
Always good to check out. So far i haven't seen any with the exception of some dust from the cardboard box. the oem's there to catch the initial pieces if there are any.
 
1 - 2 of 2 Posts
Top