Diesel Place banner

1 - 3 of 3 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter #1
I have a 1996 K3500 6.5 tubo-diesel 4*4. I tried to locate the transfer case fill plug but I can't find it. I used two references with photos. Supposedly it is on the left rear side, but there is no sign of one. Should this transfer case have a fill plug? Or does it run on the tranny fluid somehow?
 

·
Registered
Joined
·
626 Posts
I have never seen a case with no fill or drain plugs before so I would think there would be one. It may just look like a regular bolt. Most I have seen are either a internal hex, square plug or a large thin head hex bolt. Who knows mabe some one made a case sealed for life but I doubt it. Just my .02
 

·
Registered
Joined
·
54 Posts
Discussion Starter #3

No drain OR fill plugs found. They are definetly not where the book says they should be. It was cold out when I was looking at it (-5 F). Its gotten warmer so I will go out and crawl around and try to feel all around it.

If it is a case bolt as well I will not know that it is a drain or fill though, so any help appreciated.
 
1 - 3 of 3 Posts
Top