Diesel Place banner

1 - 10 of 10 Posts

·
Registered
Joined
·
2,252 Posts
Discussion Starter #1
Took the K&N off and put the 11" cone UNI with sock pre filter over the cone. Tight fit but will go, I figured if the KN would flow more than the UNI I should get close to same flow with longer Uni. Had to cut the stud off the UNI to get it in the KN box. I guess I got a KUNI air filter now



Geno
 

·
Registered
Joined
·
263 Posts
What is the part # of the UNI Filter?
 

·
Registered
Joined
·
2,252 Posts
Discussion Starter #3
Easy


UAP-908 Filter


01-1122 Pre Filter


Go to the automitive section unifilter.com an you can looksee a photo


Geno
 

·
Registered
Joined
·
220 Posts
Sounds good.

Not to hijack this topic, but what about installing a UNI
Clamp-on filter for the crankcase tube?

Is there already a factory filter on it?

Think it be worthwhile?

Thanks for any insight,

T.
 

·
Registered
Joined
·
2,252 Posts
Discussion Starter #5
Terry


Got me , this a new one for me, I will be all over my truck today and see if I have over looked one. I haven't seen one but I was not lookin for one either.


Geno
 

·
Registered
Joined
·
161 Posts
OK, anyone know what the AFE pipe size is?


Steve
 

·
Registered
Joined
·
220 Posts
geno said:
Terry


Got me , this a new one for me, I will be all over my truck today and see if I have over looked one. I haven't seen one but I was not lookin for one either.


Geno
Hehh - ok. I just crawled under the nose & measured it.
It's 3/4" so the smallest clamp-on would work.

My reasoning is this; it's "damp" around the exit
of the tube so if stuff is getting out, it's also
getting IN....

YZF1R: I have the AFE, but I'm not going to remove
the filter to measure the pipe - sorry... Just by
looking at it, I would guess anywhere from 3.5-4".

good luck,

T.
 

·
Registered
Joined
·
2,252 Posts
Discussion Starter #8
YZF1R


Should be 4 " but I would measure to make sure, The K&N is just over 4" and the UNI will stretch over the tube to make a snug fit, Slides on easy.


Geno


Never thought but Kennedy probably got these and can tell you what will fit whatEdited by: geno
 

·
Registered
Joined
·
220 Posts
Terry said:
YZF1R: I have the AFE, but I'm not going to remove
the filter to measure the pipe - sorry... Just by
looking at it, I would guess anywhere from 3.5-4".
Ok, here's the link to the AFE FAQ.

There appears to be several e-mail addresses there
that you can send your questions to.

hth,

T.
 

·
Registered
Joined
·
161 Posts
Thanks guys. I don't have an AFE but always wondered. JK does have AFE intake kits so he is probably a good lead. Thanks Geno. I just don't have the money to buy an AFE and then look for a UNI type filter only to find nothing that fits. I'll have to talk to JK. Looks like we may finally have a way to get turbo noise and the type of filtration that some prefer.


Steve
 
1 - 10 of 10 Posts
Top