Diesel Place banner

1 - 3 of 3 Posts

·
Registered
Joined
·
817 Posts
Discussion Starter #1
I set the main timing to 0 in the idle range (where the stock is negative, ATDC) for the C baro range. That should make idle timing 0.

But, when the vehicle stops, and is idling, the timing shows -5. It's 0 as I come to a stop, but -5 once actually stopped. Drive/neutral makes no difference. No table entries are negative, the lowest is 0.

What gives?
 

·
Registered
Joined
·
5,094 Posts
There are idle tables that are not present yet. They will be there soon, but not yet. You can try changing b1201 to get the truck into power enrichment mode while at idle. That is your only way at this point to control idle parameters. Fool the truck into thinking it is in power enrichment mode.
 

·
Registered
Joined
·
817 Posts
Discussion Starter #3
Makes sense. Thanks.
 
1 - 3 of 3 Posts
Top