Diesel Place banner
1 - 6 of 6 Posts

·
Registered
Joined
·
620 Posts
Discussion Starter · #1 ·
I need Torque specs and pattern for those six 10mm bolts on the upper intake!

Thanks
 

·
Registered
Joined
·
1,624 Posts
tighten like your tightening a wheel pattern. I torque mine to 'tight' on the arm wrench. I'd probably say something around 25 ft-lbs.
 

·
Registered
Joined
·
620 Posts
Discussion Starter · #3 ·
Scrufdog;1629820; said:
tighten like your tightening a wheel pattern. I torque mine to 'tight' on the arm wrench. I'd probably say something around 25 ft-lbs.
What is a wheel pattern? Like lugs?
 

·
Registered
Joined
·
1,624 Posts
like when you properly tighten the lug nuts on a wheel. Tighten in a star pattern....
 

·
Registered
Joined
·
1,182 Posts
Service manual at work says 31 ft/lbs lower and 17 ft/lbs upper.
 

·
Registered
Joined
·
620 Posts
Discussion Starter · #6 ·
teroma25;1629843; said:
Service manual at work says 31 ft/lbs lower and 17 ft/lbs upper.
Thanks a bunch for the quick responses on this!!
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top