Diesel Place banner

1 - 3 of 3 Posts

·
Registered
Joined
·
113 Posts
Discussion Starter #1
Couple questions for the experts.#1 Can the head bolts be used again?Would be used twice counting factory build.#2 How much would a line bore benefit the 6.5 w/ 599 block?#3 What change needs to be made on the 599 block from not having the casted hole in the valley like my old 506?Ok,just a couple questions of what is going to be many.Thanks for all the help,from everyone
 

·
Registered
Joined
·
6,945 Posts
Requires new headbolts - they are torque-to-yield, and the assembled stretch is permanent after use

line bore required only if replacing one or more mains caps, or installing splayed mains caps

just install your OPS in the tap in the belhousing flange, pull the wiring harness around to fit
 

·
Registered
Joined
·
113 Posts
Discussion Starter #3
Okay,I kinda thought it about the head bolts.Thought maybe the line bore might help to keep it from cracking.Looked to have a few miles on it i guess it would be cracked now if it was going to.I will figure the OPS out when i get there.Will be awhile yet.Thanks again.

By the way: I'm a electrician if i can help with any questions.
 
1 - 3 of 3 Posts
Top