Diesel Place banner

1 - 6 of 6 Posts

·
Registered
Joined
·
932 Posts
Discussion Starter #1
I am having a problem getting the scan tool to display anything I keep getting a "MODE NOT SUPPORTED" error message when I try to watch live data. Any ideas?
 

·
Registered
Joined
·
6,210 Posts
SoCal Diesel
EFILive Scan Tool For Duramax Diesel
Quick Start Guide
1) Launch EFILive’s Scan tool.
2) Enter VIN? >Yes
3) Platform> Light Truck
4) Engine> 6.6
5) Go to “Edit”>Properties>select the “Logging” tab.
6) Changed the “Scan Mode” to “Dynamic.”
7) Select “OK.”
8) Close the Scan Tool software.
9) Re-open or launch the Scan Tool software.
10) Go to “File”>Open>Open PID selection file>Duramax Imperial.
11) Select the green dot in the upper left hand corner to “Connect.”
12) Go to “Info”>Validate PIDS

13) At this point you can view the PIDS that are selected to record by using the F8 key. Double click any PID to select it for recording or double click again to deselect and turn grey to not use it for recording.

14) Select F9 for the Data page.

15) Select the Yellow dot at the bottom of the screen to monitor live data. Select the Blue square to stop monitoring data.

16) Select the Red dot at the bottom of the screen to record data. Select the blue square to stop recording and save the recorded data to a file.

This should get you started. There is more in depth instruction in the Tutorials that are provided under the “Help” Menu.


Have Fun and Happy Scanning/Tuning using EFILive.
 

·
Registered
Joined
·
932 Posts
Discussion Starter #4
Thanks, I'm off to try it again:banghead:
 

·
Registered
Joined
·
932 Posts
Discussion Starter #5
No more problems):h ...Thanks
 
1 - 6 of 6 Posts
Top