Diesel Place banner

1 - 3 of 3 Posts

·
Registered
Joined
·
581 Posts
Discussion Starter #1
Just need some reassurance I have the procedure down. I took the DIY on here and condensed them for my brain:D I plan on doing this by myself. I am going to buy 4 gallons of Transynd. I want to get as close to 100% fluid change as possible to run the extended drain interval. Here goes:

Tranny Flush

1. Drain pan
2. Remove spin-on
3. Remove pan, drain oil and clean
KEEP track of oil amount drained. Should be approx. 7-8 quarts.
4. Re-install pan and filter
5. Pour approx. 7-1/2 quarts of Transynd in filler tube
6. Disconnect tranny cooler return line (upper line on passenger side)
7. Attach 5/8” extension hose onto return line
8. Start engine and run ~3 quarts out
9. Add ~3 quarts Transynd to filler tube
10. Start engine and run ~3 quarts out
11. Re-attach cooler return line
11. Add ~3 quarts Transynd to filler tube
12. Check level

TIA
Rob
 

·
Registered
Joined
·
382 Posts
Sounds right to me.
Remember the spring on the tranny line connector.
 

·
Registered
Joined
·
843 Posts
when i did mine on my '02 i ran the truck until there was a distinct color change in the two fluids, it was very obvious. just make sure you don't run dry;)
 
1 - 3 of 3 Posts
Top