Diesel Place banner
1 - 6 of 6 Posts

·
Registered
Joined
·
200 Posts
Discussion Starter · #1 ·
I'm putting a pyro and boost gauge in my 'burban and have a simple question that I could have figured out had I done a trial fitting and not painted the pod first. Censored


Do I need to remove the stock A pillar cover and drill through it for the tube and wires, or will they fit between the pillar cover and the stock pillar?
 

·
Registered
Joined
·
3,740 Posts
youve got to drill
 

·
Registered
Joined
·
1,258 Posts
I didn't have to drill. I just ran everything down in between the two and down in between the dash and pillar. I also used 3M double sided foam tape to install it instead of drilling the four holes and using those little plugs.
 

·
Registered
Joined
·
434 Posts
Where did you tap into the exhaust for your gauge?
 

·
Registered
Joined
·
308 Posts
I read that other thread and one trick that i would like to add is when your drilling if you can get and old auto trans magnet out of the pan, you know the one that looks like a big washer, and set it around the hole you are drilling it will help to pull metal shavings out so they dont go through the turbo when done. Combine that with a shop vac too and you'll be golden.
 
1 - 6 of 6 Posts
Top