Diesel Place banner
1 - 3 of 3 Posts

· Registered
Joined
·
5,934 Posts
Discussion Starter · #1 ·
planning on using the test port on the engine, but need to figure out what type of fitting it uses, and where i can get one..


anyone have any ideas?


i'm tired of removing my bleed screw and dumping fuel all over when i sample
 

· Registered
Joined
·
661 Posts
This is how I took my fuel test sample using the Kent-Moore Gauge. I recently modified the gauge by adding a tee and needle valve. This allows an easy way to get fuel samples and/or bleed the system when changing filter. The lift pump (while not necessary) also aids this process.



 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top