Diesel Place banner
Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
3,557 Posts
Discussion Starter · #1 ·
I just installed my new billet fuel pickup from TTS. Very nice kit with everything needed for install. Took about two hours. I also cut off the end of the supply line above the fuel cooler where the new fuel line goes, which is very restrictive looking.

I'm running a tow tune in the truck and all else stock. I figure the tune is 50-70hp(just a guess).

Anyway the tune never smoked one bit with stock pickup and this tune. After pickup install, I now see smoke during WOT.:D

No backup on a dyno or strip, but seems even on a mild tune this pickup helps deliver fuel. Should multiply the results with lift pump and big tuning.

Thought I'd share my thoughts.
 

·
Registered
Joined
·
1,550 Posts
Thank's, that's good to know.
 

·
Registered
Joined
·
11,953 Posts
Any before and after rail loggs?
 

·
Registered
Joined
·
3,557 Posts
Discussion Starter · #5 ·
ratlover;1612807; said:
Any before and after rail loggs?
Phil, I have logs of this tune and the stock pickup, I'll log it now and see if there is any difference. Although the pressure was very high(actual equaled commanded) with stock pickup, so don't know if this will help.
 

·
Registered
Joined
·
11,953 Posts
Just wondering.....I know on my LB7 when I added fuel supply on a biog tune I picked up SOTP, smoke and my actual actualy came up to the demand.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top