Diesel Place banner
1 - 1 of 1 Posts

· Registered
Joined
·
89 Posts
Discussion Starter · #1 ·
Ok guys, I have been lurking around here for sometime looking at the fuel filtration options. I am leaning towards either the CAT or Racor setup. I know these have been discussed several times but I have a couple questions which I can't seem to find answers too.


First off, I have noticed that alot of people seem to be mounting them along the frame rail by cutting the fuel lines. How are you guys going about doing this without fear of getting metal particles in the fuel lines?


As far as setup choice. Is there anywhere online to order an entire Racor assembly similiar to the Nicktane CAT installation? I am leaning towards the Nicktane setup although I like the water bowl and drain system of the Racor.


How often would one have to change the OEM filter once you have a pre-OEM filter installed?


Thanks for helping out a newbie.


Curtis
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top