Diesel Place banner
1 - 4 of 4 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
I have searched and I can not find the answer I am looking for so I am turning to you all. I have a 6inch Fab Tech lift w/35 inch Toyo's. I was wondering if anyone knows if 37's would fit. I am not to worried about a little rubbing and triming. Any help would be appreciated.

Thanks in advance,

John
 

·
Registered
Joined
·
633 Posts
I would say no, unless you trimmed a lot! With fabtech already bad angles, I wouldn't crank the bars toooo much.
 

·
Registered
Joined
·
159 Posts
install cut outs and 37s will do fine , no rub and i can crank on it in the bumps
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top