Diesel Place banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
288 Posts
Discussion Starter #1
Can't remember the company name off the top of my head, but they make that replacement driver side exhaust manifold. Looking at putting in egt gauge, and it is already tapped for sensor. Figured I could kill two birds with one stone. Anyone use one of these and do you think it was worth $300?
 

·
Registered
Joined
·
376 Posts
BD is the company:) i was planing the same thing
 

·
Registered
Joined
·
69 Posts
Just let it idle and drill/tap a hole in the one you have. It's a whole lot easier than changing out the exhaust manifold.
 

·
Registered
Joined
·
22 Posts
It's called the Full Bore exhaust manifold from BD Diesel. We stock them. They come pre tapped to accept a pyrometer thermocouple. If you have any questions just give us a call.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top