Diesel Place banner

1 - 2 of 2 Posts

·
Registered
Joined
·
414 Posts
Discussion Starter · #1 ·
I Censored up a little up yesterday:( and accidently broke the little plastic dingys off the side of the smaller (the top) of the two engine wiring harness connectors on top of the (LB7) engine where the little grey lever is supposed to swivel on.

Does anyone know if it's possible to buy (and where) a replacement connector without the entire engine wiring harness and also if it's somehow possible to pull the pins out of the broken connector and put them into a new one? I have to use a plastic zip tie to keep the connector together at the moment and am sure a dealer would ask about it next time I take it in.

Anyone else ever have this happen, what did you do?

Thanks,
Tim
 

·
Registered
Joined
·
16,609 Posts
I am sure you can get the connectors from Delphi (I think that is the manufacturer) it sure would take a lot of time to change all the pins over. No room for error either.
 
1 - 2 of 2 Posts
Top