Diesel Place banner

1 - 4 of 4 Posts

·
Registered
Joined
·
285 Posts
Discussion Starter #1
2005 LLy

I am in the middle of my EGT probe install for my banks six gun. How deep is the probe supposed to stick into the manifold? The pointed end of the probe is probably 1/16" to 1/8" from touching the side of the manifold. Is this too close? It doesnt say in the directions where it is supposed to go.

Thanks
Dave
 

·
Registered
Joined
·
1,621 Posts
Right in the middle...half way...as stated above

:exactly:
 

·
Registered
Joined
·
285 Posts
Discussion Starter #4
Thanks for the replies. I just installed it as is. It is probably 1/8" from touching the side of the manifold. It is the non adjustable probe so I guess it is what it is. From what I read on here the probe may have a short life with it being that close to the exhaust manifold. If it goes out I will have to make it work some other way.


Dave
 
1 - 4 of 4 Posts
Top