Diesel Place banner

1 - 4 of 4 Posts

·
Registered
Joined
·
112 Posts
Discussion Starter #1
:wtf:
My truck Battery went dead and now the edge screen is not working.
Is there a fuse and/or where is the unit powered from?
Haven't gone out to try the truck yet but I don't think the unit will be putting out any HP I think the unit was on #1 setting so it will be hard to notice if it's workin.
Has anyone had this problem?
it's cold today arround -18C or like -1f
I have seen it colder and screen still worked
it had a slow responce but so did I

Regards,
Brian
 

·
Registered
Joined
·
440 Posts
Try unhooking the module and reconnecting it. If that doesnt work, call Edge, Im sure they will take care of you.
 

·
Registered
Joined
·
112 Posts
Discussion Starter #3
sweet it works
thanks
i took it one step fether and disconnected the battries
and also cleared all the codes that where created by low power

This site rocks
 

·
Registered
Joined
·
514 Posts
jugghack2;1593475; said:
sweet it works
thanks
i took it one step fether and disconnected the battries
and also cleared all the codes that where created by low power

This site rocks
Load test your batteries. My edge took out my primary battery once and it did the same thing. Unplugged it, jumped it and it fire right up. Edge sent me new module but not the battery. It was a 3 plus year old Delco any how. New batteries and new Beta Test Module running fine for over two months..
 
1 - 4 of 4 Posts
Top